Recent content by vettebullet

Like new condition few months old, Barra 250z .22 cal with power kit and trigger kit, trigger has been tuned and is lightweight crisp 2 stage trigger. Added set screw allows more trigger adjustments. Much much improved over factory stock. Comes with 2 mags, single shot tray, original manual and...

I had a vulcan 3 .30 70mm...it loved the .3063 avs 61 grn at 960fps...very very accurate at long range 150 yards and further....truly impressive

I put another on stock on my barra

Any gun that has the ability to push the heaviest, highest ballistic coefficient slug at 985 to 1010 fps through a unchoked, 700mm to 800mm in lenght with the correct twist rate to stabilize said slug. .224, , .254, .257, .284 I have found the most accurate guns I own or have owned usually...

Since i cast various .224, .257, .284, and .30...its no harm if a slug is a tad over to toss it back and remelt. For example in .257 I have a mold that casts 60.50 grain if it up .20 (60.80 or down .20 (60.30) if it exceeds those parameters it toss to remelt. That way it from lightest to...

So here's my advice with slugs in any gun, especially ones with unchoked barrels. You can try a ton of different slugs in different sizes till you find one that's the most accurate. Nothing worng with that method. Or you could slug the barrel and measure the slug with a micrometer to find a good...

You need heavier hammer weight to over come the higher reg pressure or heavier hammer spring or combination of both more hammer weight and stronger spring

Sorry to hear of the horror with the trigger that's always a bummer Im not too far from oceanside aswell. Id be happy to do what I can to help fix or tune your trigger. Your in good hands with Gerry. You also have an option....PM sent

This is the lenght and weight of .284 (7mm) from the noe 106 mold that has been drcked down

I have a 34" 1-18 .284 tj barrel on my custom texan. Its more accurate than 1-14 twist .284.I have the noe 84 gr mold which wasn't as accurate in either twist as the noe 106 mold i had decked to drop at 91grn....its super accurate with 1-18 twist at 1010fps 91grn hollow point. Its probally best...

Dirty air or unfiltered air, debris in the air cylinder, could be delrin seat failing, could be a number of things

Overall very good platform from factory

Replaced trigger springs added set screw to further adjust first stage travel After I polished all surfaces, pins and connection points. I ported the transfer port to match barrel and valve port. I added 7grams of hammer weight and increased spring tension

I havent had any problem with mine. I absolutely love the platform...I did some upgrades, porting, trigger polishing, heavy hammer, stronger hammer spring, increased reg pressure to 2400psi and got it to 1000fps with 33.5 grn nsa slugs. The trigger spring were swapped when I polished all trigger...

Looking for ar stocks that at minimum have a cheek riser