Recent content by travandfx

FYI. Update . Rifle was returned and is work as it should , the 2 issues i had was. The orignal issues was the little reg screw o-rings and the second issue was when i changed out the reg to a new kit it damaged the seal in the body as advised above. They have sent it back with 135 bar and it...

Thank you for that picture it was a great help . The rifle has been sent back to FX under warranty , due to the fact that the reg had never been out when it started leaking . So hopefully it is repaired without issue .

Thank you . That sucker is very hard to see. FX Australia have offered to do the work under warranty .

I have looked and cannot see a ring anywhere in the Body , is it just below the threads ? At the bottom, at the top ? I tried the new reg and it leaks exactly the same, I tried it in a friends Crown and have no leaks . My next move is to send it back to FX here in Australia under warranty .

No I havent as I cant see where it goes , I cant feel any grove or runner in the hole ,the kit came with one but , Does it go in the body or on the Brass part . Thank for the advise . what I purchased was a new body with rings installed and new valve with rings installed , on the out side of the...

Hi All .Rifle is a Crown Continuum, .25 cal 2 years old , How it started , I notice my reg had dropped from 150bar to 140ish and shot dropping low to normal, so I followed instructions in manual and gave the reg screw a 1/4 twist back , shot a few times and back to 150bar , next morning my...

Gold Tip Swift work fine. Its all about the inside diameter of the shaft . It is 7.7mm or 0.30315 inch Just contact the dealer for Umarex and check . I have a Crown AB kit . The gold tip are I.D. of .300″. and they work fine BUT they take longer to load due to air pressure in the tube. HTH

Old post. But I will add my thoughts . I just purchased the arrow kit for mu Crown mkii continuum . at 40yard im max on my scope turrets with my 25cal slug set up . It is loud ,BUT its not the same crack as the high with slugs, and doesnt seem to travel far ( Sound) I shoot the slugs on max and...

Thanks everyone .

Thanks would you know the ORing size on the fx crown mk2 its 25 cal . I think I should get a spare or 2 for the tool kit . Thanks for your advise 

Gun on low. Wife on high . After 20+ years of marriage Im smart enough to keep my Volume on low , But the expression on my face still gets me in trouble 

Hi Guys.. I was teaching the Wife to shoot with the FX Crown and she pulled the trigger with the Action back . It slammed shut and scared the hell out of her. Considering I had spent XXXX time explaining the procedure its still my fault . I tested it after and it shot right buy 2 moa for a few...