Recent content by TonvanderLinden

Dry air is actually more dense than moist air at the same temperature.

(y)I contacted Hill, a few weeks ago, asking for advice on finding a decent water/oil separator. The lady from customer support told me that in a couple of months Hill will release their own.

Thanks (dankjewel) for your reply. The Huma reg I've got installed is a Gen 3 HP, wich can be adjusted between 110-165bar. Since it has been recently installed, I'm guessing it has nothing to do with the regulator itself. There was one other thing about the way the gun was setup, that made me...

Oeps, I meant 1st at 185 and second at 150.

Sorry, I meant: 1st reg at 185 and second at 150!!

Hi there fellow air junkies, When shooting my M3 at the range, I noticed a change in consistency on paper the more I shot my rifle. At some point I found out that, during shooting, my second regulator pressure would rise around 10 bar with the original FX reg installed. I brought the rifle to...

I went out to the range again yesterday, and kept a close eye on the second reg during shooting. I shot around 150 shots and saw the 2nd regulator pressure rise up as time went by. It started out at 142bar and at the end of the session it was at 148bar. So, I'm guessing there's more at play than...

Thank you so much for answering my question.

Hello, My M3's second reg tends to be around 10-12 bar higher than the set pressure, everytime I come home after shooting my gun at the range. (outdoors temp difference with my house: 22 degrees (fahrenheit) After dry firing a few shots it returns to normal. Is this normal?? Sincere greetings...

My thoughts exactly.

Not hard at all. Watch the instruction video a few times, make sure you've got all the right tools for the job (caliper, grip pliers, locktite, etc), follow the instructions step by step and take your time!, if you are running into problems; don't panic, post them here and wait for replies until...

Same problem here. Except my 2nd reg won't deplete after dry firing or turning the adjustment screw. Are there alternatives to these methods or am I just screwed?

The whole ordeal made him learn a valuable lesson about how to handle a rifle. Ego got a little dent but rifle is oké. 

He's getting a new mag on tuesday from a local airgun store, so I'll tell him to bring his rifle and have it checked by a professional. 👍

Thanks for the help! I forwarded your suggestions to my buddy and he just called, telling me he managed to solve the problem. There were 8 (!!!) Pellets in the barrel.