Recent content by SunnysideScott

Years ago when I had single shot PCP‘s, I would wrap foam pipe insulation around my scope tube with holes punched into it, to hold the pellets with their skirts available to grab quickly.

I was wondering if anyone here knows of any aftermarket triggers that would fit the Benjamin Gunnar? Or has taken theirs apart to tune it? Thanks, Scott

What batch parameters do you use for weight and diameter? Do you discard certain batches or just shoot them in their sorted batch?

Right on, thanks for the info. I researching my next hunting rifle and have the V3 .25 cal one a short list.

Thank you, I’ll put some spacers behind my hammer spring.

Nice, years ago a buddy got us a paying job, because the company was preparing for a USDA inspection.

Same here, 6 months no issues filling gun.

Really liking my Impuls Air 1350 in .25 cal.

Great group, I use these in .25 at 883 Ave, but they don’t shoot near as good as JSB Exacts. I might need to try diffe speeds.

I need to get off my butt and make the switch, just not sure what system to switch to These days.

50 shots from 3200psi to 2000 psi, transfer port open all the way.

Great write up. Mine is .25 and I bumped my reg to 2100psi, and added about 1/4” spacer to the hammer spring.

Getting back into PCP‘s after years in the powder burners, I can say that I enjoy the ease of use and graphing that comes with the FX pocket crony and their App. I have a Lab radar, and Crony Beta. I am shooting my air rifle into my lower lot, which has me shooting within a few feet over a berm...