Recent content by Steyr

I have a moderator in 22cal which I would like to use for 25cal gun. A quarter bore inch rod fits OK through the moderator but is very snug with very little clearance. Do you guys think this would be OK or I would get lots of clipping, damage the moderator, etc,

yep, just yank it off, its the ball bearings keeping it in place. the plastic bag is a nice tip as there are springs beneath the ball bearings btw, how did you work out the leak was at the front gauge if you couldn't remove the cap?

are you sure its leaking from the barrel?

i was wondering how would you know that it is the regulator that is leaking? So could this work: turn the regulator external adjustment screw anticlockwise to reduce regulator pressure to the extent that the plenum empties completely and the regulator manometer is showing zero. If the cylinder...

wondering have you tried any heavier zans in your .25 Huben: 38g .253 41g .250

good point about the barrels. I already have a 2018 Huben .22 calibre. Planning on getting a .25 calibre from Huben Shop in Spain to shoot heavy slugs. Anyone try the Zan Projectiles Slugs that the Huben Shop sells https://www.hubenairguns.shop/collections/zan-projectiles

Can anyone recommend (heavier) slugs for Huben K1 .22 & .25?

I have a .22 Huben K1 (2018) version. I see that Huben Shop sell a .25 barrel & magazine (not cheap however). I was wondering whether anyone has swapped out their .22 barrel for the .25 barrel and if so was it a straight swap, were there any fitment problems etc. with the shround etc...

have just watched gregors video would recommend anyone thinking of buying the pistol to use gregors affiliate link as per an earlier post - he deserves it. without his takedown videos I would never have been able to repair my huben k1...

can anyone recommend me a lightweight LPVO scope for less than $500?

hey guys, thanks for giving me starting points to investigate. i suspect you are right and its an issue with the magazine indexing mechanism. one thing I have noticed is that the magazine release arm is not as stiff as when i first brought it. also i can spin the magazine freely clockwise even...

I have had a Huben K1 for the past 4 years (2018 model) and taken it apart a few times to sort out leaks and even rebuilt the regulator so I know my way around the gun. However, recently, when I shoot the gun (Reg 16mpa, Air cylinder 240bar, power adjuster 15 clicks from closed), it buzzes...

I brought my Leshiy 2 with a 0.22 250mm barrel with the standard short suppressor a couple of years ago. If I change the barrel to 0.25 (or 0.30) do I need to buy a new suppressor or will the OEM suppressor still be OK with the larger pellets?

i would assume that the marks on the huma reg are fairly accurate, to say +/- 5-10 bar, i mean thats what we are paying a premium for - an easily adjustable reg with markings.

i'm betting that the circular white disc with the calibrations is not fixed and will rotate, so wouldn't have to mess with the needle. So lining up the disc with the needle at dead zero will help with accuracy (of course limited by how inaccurate these things are).