steve-l's latest activity

I understand your concern, but Your choice of sights comes down to your intended purpose. I am a very experienced pistol shooter and...

With a pistol I miss a lot, but even when I miss I am close enough to get their undivided attention. I don't use open sights. I use ...

No time, no matter what tool you have to calculate holdover at distance when shooting at birds. It is instinct and experience with your...

Yes, I have hit pigeons at 100 meters. To do that, I hold high about 30 inches. However, the GK1 is a pistol and I use my GK1s usually...

I must commend Weevil for his efforts. He is on the right track, but the limited space in the shroud available is a substantial issue...

Mark, Perhaps stating that your targets will not be distorted over time by soft lead pellets, would clear up any doubt that may exist...

I have never shot at AR400, so I cannot say how durable it is, but I can state that if mild un-heatreated steel is used, it must be at...

1/8" mild steel plates will be destroyed by .25 cal pellets at anything above 600 fps at 25 meters distance. .

Mattias, AliExpress for all parts including the 2mm reflex sight. My glass center to barrel center distance is 29 mm.

Cost and distance control.

It is a personal thing. Target acquisition must be fast and instinctive when pesting. .13 inches makes a big difference to me. The...

HPA is very dangerous! Professional compressors use high quality (read expensive) components. When I configured my Bauer compressor I...

I never trust auto stop on anything! As far as the gauges I don't trust the ones on the compressor. I fill tanks and, on the valves, I...

MIchael a reflex sight is the only way to go, but going to the rail adaptor you chose sets the sight height too high above the barrel...

I have stated this before, but I will repeat this fact again. Most commercial moderators have bores much larger than optimum for good...