Star7's latest activity
- SBy in large ... THIS IS NOT REALISTIC. Able to hold even MOA accuracy at 100 y is a quantum achievement very few ever pull off. While...
- SWell I have nothing good to say about slip on lids.
- SThey're stupid expensive. I have a tin I bought to try on pests in lieu of wadcutters. Never used but a few of them for accuracy...
- SAnd so are another 20 guns.
- SAs someone with a tendency toward hand-wringing about doing things that could potentially damage my belongings, I will just say that...
- SStar7 replied to the thread N/A HW95 .20.That weld seam blows my mind. This situation has really gone over the top. Good photo of a dreadful situation!
- SThey're also using welded tubing now. The weld seam is sometimes recessed, allowing compression and grease to bypass the piston seal.
- SWadcutters are great for pests (at reasonable ranges). They're better than most gimmicky hunting pellets that most springers can't...
- SIt would be nice if wadcutters were still available for the paper targets
- SA couple three years ago it wasn't BS. During Covid it was hard finding good quality pellets in any caliber. 20 caliber went out of...
- SStar7 replied to the thread N/A HW95 .20.1 Year old HW95L in .20 shoots 13.23 to 14.2 fpe with a number of different pellets at 45-60F and 1200 ft altitude. A newer HW95N is...
- SHaving just bought a new truck and dealing with the whole car dealer experience, I very much understand why they would block weapon...
- SImportance of SecoLube500 and other high flash point crankcase oils is resistance to detonation (dieseling) in high-pressure cylinder...
- SStar7 reacted to doninva's post in the thread Sightron S-Tac 4-20x50 FFP, any pertinent experience? with
Like. Eric at Scopewerks is great to work with. I had very little luck with the other wheel you mentioned also. Don - SFinished the piston for my Gamo. Machined diameter closer to size, as opposed to factory piston that has a lot of clearance. Is that...