Recent content by sps3172

I use a motorcycle chain lube, containing moly, on the cocking pin. It's typically thin enough to flow into the joint and then thickens and is tacky enough to stay put. I happen to have a can of PJ1 Black Label...but there are quite a few varieties of motorcycle chain lube with moly in them.

For those who were saying these were like hen's teeth.....here's one for sale.... https://airgunwarriors.com/classifieds/show-ad/23099/wts-weihrauch-hw97k-20-cal-w-vortex-scope/airguns-springers/

Looking for another Maccari TX cocking shoe. PM me to let me know if you have one that you can part with…hoping for new or at least unmodified. 

RB, You've probably already seen this but in case you hadn't, I wanted to point out a thread here about a group in Mass. going through the process of creating a new course. I would expect lots of good info in that thread for folks in our boat...

These pics are from page 9 of the AAFTA handbook. Using a 'stop' would at least simplify the process of getting the gun in the same place on the bi-pod each time.

Has anyone experimented with epoxy/glass bedding a spring gun action? Something like this might address the issues associated with stock screws coming loose. The epoxy is used to make a non-compressible attachment point in the stock as well as lock the action in place so no movement happens in...

Hi RB.... If you have a location, that's the biggest part of the battle, I think. The next thing to be conquered is buying targets. My understanding is that Air Venturi offers a discount on the 'rat on the run' target to startup clubs. I believe you have to buy a minimum of 10 for the...

I've noticed that JSB/AA Diablo 8.44 pellets are a very easy push into the breech of my new TX200. I have some OOOOLLLLLDDD Crosman Premier Lights that are a much tighter push into the breech. The old CPLs seem to group much better than the new JSB/AA Diablos 8.44 pellets. Since I can't buy...

Let me know if you have one that you can part with...hoping for new or at least unmodified. 

Anything in the works down in SW MO yet?

I linked this piston further up in the thread... https://www.airgunspares.com/tx320sairarmstx200mk2pistonbody.html ....it provides the stroke length of the MK1-MK2 guns with the modern latch rod geometry of the MK3 guns. When viewing the notches on the MK3 compression tube you see that one is...

Any chance you could share some details or provide a link to show how to properly 'size' a seal? Thanks!

I think the best way to 'short stroke' a MK3 (while keeping the stock bore) is to return it to MK1-MK2 stroke length with this piston. https://www.airgunspares.com/tx320sairarmstx200mk2pistonbody.html My understanding is that the FAC spring in the MK3 is the same as the sub 12fpe spring in...

I live near St. Louis.....to my knowledge, there's no FT activity anywhere in the state of MO. I've been beating all the local bushes to find folks that might be interested in shooting some field target in this neck of the woods. I'd be willing to do some legwork to find a place to hold an...

Somewhere I saw an aftermarket version of this part......of course I can't find it again. Anyone else?