Recent content by slickrock

I'm looking for unrestricted (e.g. USA), tuning recommendations for a 0.30 Cal 350mm, Behemoth-ed L2. Preferably with older regulators. Current amo is NSA slugs 47.x and 61 grain and FX 50.x pellets (JSB Exact clones). Objective is accuracy over speed or shot count per fill. If any of you...

This sounds similar to how the 225 works and like you I find it tedious that they are controlled in separate areas and not ganged together. POA for each gun used likely be different and will affect the ballistics (i.e. not just what ammo is used), so they are intrinsically linked to begin...

Fare enough. To anyone who bought a .30 L2 (preferably with 350mm barrel, but not picky) as new, what were your installed jet sizes?

Speaking for factory condition, for the current L2 standard offerings, what are the jet sizes come installed in 350mm barrel in .25 cal, .30 cal, and 9mm, as well as respective stock pressure settings? I'm primary interest in the .30 cal numbers but I'm also curious about the calibers on either...

The day/night increase in resolution is noticeable as well from the videos. Dare I ask if there might by a trade-in / upgrade option for existing customers who had purchase the TNC225R prior?

What is the shot-to-shot speed you are seeing of the Apex vs. REPR vs. original internal regulator?

It does take quite a bit of impulse force to free it and a quality pin punch. The trick is a way to keep the plug stable when hitting it. Here is what I did.

Another aspect of this is the wear and tear on the indexing piston and gear. Using high reg pressure I feel puts undue stress on these parts and they wear out quicker. I use 61 grain slugs and take no prisoners. Mind you I have yet to tune my setup much. I have a chronometer on the way on the...

With the stock stock? If so, I can do 3 cassettes before the reg drops. Mind you, I'm using hefty 61 grain NSA slugs at about 145PSI with 0.6mm jet, never chronode (soon to be remedied). AFAIK, this setup is untuned and likely inefficient.

I didn't use a vise. I used a couple of sample blocks of synthetic patio board I picked up from the hardware store and situated the flat part Forward Plug assembly on the edge of the blocks so the assembly could lie flat. I then used a pin punch with a tack hammer with some firm strikes. The...

Bump. TLDR: to anyone with 350mm 30 cal L2, what is your power jets sizing/count configuration?

OK, I have a 1st gen L2 250mm AP 30cal with original internal regulator with a single power jet (2nd is plugged) that was most likely manually bored by Edgun. Recently upgraded to a 350mm 30 call AP barrel and now have the standard power jet kit to experiment with. Running JSB Exact 51 grain...

Cool. So, where did you source the tubing how did you fabric the CF barrel to be compatible with Tri-lug endpiece? And how did you fabricate the perforated endpiece? 3d? A 5db reduction would well be worth the investment to DIY this.

A 5db reduction is significant! Does the increased diameter affect usage of M-Loc holes? Perhaps you can share the process making this reflex shroud to the forum. Thanks.

Wait. Are you saying the reflex shroud of the Behemoth is longer with 350mm L2-9 than the Behemoth-Reflex setup you can buy separately? Clearly would prefer the longer reflex shroud. Wonder if that can be ordered separately.