SLICKNICK's latest activity
SLICKNICK replied to the thread Yong Heng after piston replacement.https://a.co/d/5g3UyRg That small round disk, gets carbon build up after a while. If too much builds up it, will diesel (Detonate) ...- SLICKNICK replied to the thread Yong Heng after piston replacement.take hi pressure head off and check seals, and also check the round check valve on hi pressure cylinder head. Too much carbon buildup...
- SLICKNICK reacted to Ezana4CE's post in the thread Benjamin Benjamin Bulldog .357 (original) Shooting .35 Seneca Airbolts with
Like. It’s been a few years, but I’m back at it. This was my first PCP. Not just this platform, but the same rifle in the photo. I probably... - SLICKNICK reacted to The Archer's post in the thread N/A Big Bore Photo Thread -Yeah It’s Time to Show Off Your Big Boy Toys! with Like. AEA Zeus .72cal… The Beast! nuff said. Currently available and listed in the classifieds.
- SLICKNICK reacted to The Archer's post in the thread N/A Big Bore Photo Thread -Yeah It’s Time to Show Off Your Big Boy Toys! with Like. AirForce Texan LSSCF .510. Heavily modified and very accurate at distances that defy the limitations of air rifle norms. When tethered...
- SLICKNICK reacted to Ezana4CE's post in the thread N/A Big Bore Photo Thread -Yeah It’s Time to Show Off Your Big Boy Toys! with Like. If you’re into big-bores and like to show off your guns this thread’s for you. So let’s see your guns, setups, and savage long-range...
- SLICKNICK replied to the thread Tuxing gaskets.https://a.co/d/cgzFjo6 seal kit works on many compressors. It may have the seals you need
- @maxtrouble Elk, moose, bear, or mule deer are good options to consider where permitted. Bison is not out of the question for those...
- I did unscrew it enough to where I could see the red seal however I did not remove it all the way to see if that would work. Thank you...
- SLICKNICK replied to the thread Umarex Umarex Hammer Dead Trigger?.Check the safety on the stock. You have to screw out enough to see a red seal. Or put it aside, and put back when done shooting
- SLICKNICK replied to the thread Watch out Tuxing twin cylinder.Agreed. Nothing beats a good wire nut. 😁
- SLICKNICK replied to the thread TXEDO11 Circuit breaker.it also depends what hi pressure head you have.
- SLICKNICK replied to the thread TXEDO11 Circuit breaker.clean your check valves. Make sure water is not sneaking in to hi pressure side. Probably a bad seal, and water is building up in...
- SLICKNICK replied to the thread TUXING 4500PSI PCP Air Compressor Review.maybe if it’s a ton of water. The pump starts and gets to 3000 psi. A ton of water if everything is tq correctly, the piston rod (the...
- It reminds me of an issue I had in a shop machine. A small piece of debris was beweet 1 leg of the contacts and it worked fine until...
