Recent content by Sleeper192

Sorry, I just saw your question. I have sold my Vulcan, and no longer have the part. The key is in the message above, 31.. outer piece , and I cut it between 2 and 3 fingers wide. My post of March 3, 2023 shows what I ended up making. Hope this helps. Sleeper

This listing has been renewed

This listing has been renewed

I really could not tell any difference, but I ordered it when I ordered a heavy spring. I got into a Revere, which is what I was headed towards before I traded for the V3. The V3 is a great gun, and has put many squirrels in the freezer, but I really prefer a traditional style rifle.

I am not sure, I think I made it about 2 1/2 inches but I bet it is not critical.

This listing has been renewed

This listing has been renewed

This listing has been renewed

Vulcan 3 .25 500mm Lots of upgrades! Over $150 in upgrades and over $150 in ammo Huma Regulator installed ( original also included) $89.95 Talon Tunes heavy hammer spring installed $19.95 Factory de-pigner installed $39.95 2 Factory mags Fill Probe Sling 1/2 UNF adaptor 0DB Moderator Barrel...

IN

Hilarious!!!

A couple of my neighbors have had a ground hog setting up residence along the river bank. They knew I had the air rifle and asked that I evict him. I am to the point in life that I normally just shoot what I eat, but this critter needed action. I recently traded for a Vulcan 3 .25 cal with...

K9air, do you have a Vulcan 1, or a Vulcan 3? I just asked the seller if his mags would work in the V3 and he said no. Thanks Sleeper

Thanks so much Sleeper

Have you tried them yet, and are they as good as the original? Also, how much was the shipping? I have a vulcan 3 and want some more 25 mags Thanks Sleeper