silverstreak's latest activity

I used a 1” latex paint brush and tapped it against the handle of a mallet that I held horizontally above the target.

pretty cool & different- what are you using as an aplicator ?

This DIY garage art was inspired by the Utah Airguns custom shop, and is dedicated to the 80's themed RMAC 2025 event! I don’t have the...

Yes, just to confirm, this new filter does have the pressure maintaining valve. At approximately 2000psi it opens

I bought this model B, years ago, from the original owner. it came with the original owner’s manual and 2 cans of pellets.

I put the trigger “kit” ( little piece of plastic) in, better but a fine line between setting up 1st stage travel and weight. When you...

You may read that it is possible to grind the HW sear to take a TX rod (like I did) but I wouldn't recommend it. Yes it will function...

yep... likely it is a springer, set any shim down in the the bottom of the receiver hole. Set the pin depth as deep as possible then...

Strange Hatsan could not help... They seem to sell loads of refurb rifles. They may do not have new parts to sell, but if you try...

Try putting out an add out for a parts gun... your takin a h*ll of a risk. You had 2 close warnings. Thank god no one was standing...

Put a little bevel on the point of entry for the probe to stop it from chewing up the orings. You can use an oversize drill bit or a...

Good luck ,high-pressure air is no joke. I get kind of nervous when I fill a tank or work on my airguns.

I think the guages on the King are ugly as H@!! sticking out the side at a angle like they do, plus easy to hit and break.I think the...

I've been ordering O-rings for my P35s almost from day one. They come with a set and tools but I wondered about the quality and decided...

I just want everyone to know that Mike Ellingsworth is going tomorrow for open heart surgery. Please keep him in your prayers. I have...