Recent content by Shaky2

Way to expensive to shoot. I think they screwd up making this one.

I'd use a minimum of two cylinders every time I took it out. That's 25 bucks. Way too expensive in my opinion.

No it will only fit if you use something to remove part of the bottom of the moderator so the air tube can clear it. I used a angle grinder with a flap disc to remove it. I marked the bottom of the mod while it was installed then with the barrel off and air tube with plenum installed I marked...

The seller on eBay lied to me several times and then it hit me. He's saying anything just to get them sold.

I did for about 30 miniutes then back to co2

I have a Urban and a Notos and I would choose the Urban

In

If it won't degas with the screw you back out the gauge just enough to hear air coming out

Mine likes FX 15.89 best but shoots other sizes and brands good too

From the end where the pellet comes out

If you don't want to save the front part of the moderator I used a angle grinder with a flap disc. I ground it down behind the 5-1/2" mark then used a hacksaw to cut a groove all the way around. I put it in a vise and the twisted the muzzle end and it came right off. That left the little piece...

Did you get it off?

Its been almost a year since I had mine apart to replace the reg. My memory is a little fuzzy but none of it was hard to take apart and put back together

Its been a while but I think there's 3 set screws where it meets the receiver.

That's great!