Sergey1972's latest activity

I have owned 7 FX rifles, all of which have been capable of one hole groups at 50 yards. I rarely shoot past 70 yards however I have on...

If incomming pressure is too close to 140 bar then on gun reg doesn't open very wide creating the flow restriction. In addition to...

Does your whip or filter have a check valve? Pictures of setup help. Tuxing small silver filter has a check valve and secondary bleed...

There is a breaker on the compressor. Little push button on top near the switches.

A few years ago I had a hose disconnect around 250 bar. Had the same problem ended up being that it blew the O-rings out of the female...

Run it with dead head plug. See if it resets. Only thing I can think of is check valve gor stuck in the ope position. If not back...

If water is leaking pressure will go to water tank and blow its lid off. Been there dine that. Leaving cooling running while...

This listing has been renewed

found it. its on amazon called vc3 thread mate

Loctite has an antivibration product. Cant remeber what it is but we used on a spring adjusting screw a liftime ago. Paint it on the...

Angled scope mounts will center the reticle. Or shim the scope with plastic in the rings. Should be lots of discussion if you use...

The only thing they respond to in a situation like this is pesistent work on your part. 2-3 hours claims through aliexpress, bad...

Leadtime usually means time to ship. Add shipping transit time for delivery date.

Lower the onboard air so you can tune, then increase it for use.

I wouldn't call myself an unregulated PCP tuner, but I do shoot a lot of unregulated guns, even in field target, and it looks fine to...