Scotty1's latest activity

I’ve purchased several O-ring kits over the years. They’re great for having a wide variety of O-ring sizes except the one I need.

when you go the the ultimate ballistic site, RMAC should be highlited at the top...click on that. Can be separated down to relays. It's...

Take a look at scope aid https://scopeaid.com/ Maybe somthing that could help ya out on any scope .

Hey guys as usual, thank you all. What am unbelievably helpful community of dudes. If society worked half this way, the world would be...

I usually just sit it on my shooting bench, behind the muzzle a few inches and facing down range. Placement is not critical for me.

Tonight’s carry. I’m just buttoning up the final tune on it this Prod. It’s going to be one of my favorites to carry. Tad under 5 1/2...

@Scotty1: thank you sir! I just wired the yellow /green to ground. And discovered the yellow green wire had a ”ground “ label on it. Yep...

The yellow/green is your ground, connects to ground bar in the panel. The neutral is not used in your circuit.

Rotate the scope in the rings a little bit counterclockwise from the rear and test again. Mike

Worth the “gamble”? For whom. I thought the transaction was a purchase by a consumer lead to believe a product works as advertised… Not...

The 30 day warranty speaks volumes, doesn't inspire much confidence. How many cc’s of air could possibly be lost with a reasonable...

That's a poor excuse. The EaZy Fill has no business being a component of high pressure if it cant handle the stress. Could you imagine...

I believe the Prophet 1 hammer will work, but Rok will respond and have the answer. I had a Priest2 with the upgraded side lever block...

Here you go, they also have the Priest 1 hammer and a couple different sears

I don’t believe it would work, as the P2 has a balanced valve, and the Priest/P1 do not.