Recent content by ScopeFX

M3 600MM at 125 bar 2nd reg likes to shoot them at about 880. 900 FPS wasn’t bad, but wasn’t at good further out. Would shoot them 930 FPS at 16.

Would like to see the slug kits for them if they come out.

In

Those were NSA 38.5gr

Glad you had good luck! I need to try the .250 too. My Impact seemed to like the .249 from my initial testing.

Somewhat struggling getting the SD/ES to tighten up. Info below. My pellet M3 is in the single digits but this one is hovering a bit. Impact M3 .25 700MM Slug Liner/Tungsten Hammer Reg 1: 190 Reg 2: 155 Macro: 15 Micro: 4 Max speed is about 1035 fps or so. I know people say to be 3-5% lower...

To my knowledge there are not magnets that I know of in the M3 at all. But, wait for others to chime in as it is a medical question.

I’ll try and document my barrel findings. Have some NSA and Javelins on the way. But also ordered up .249 and .250 of the same grain. I had horizontal stringing with the .250.

My M3 likes the .249 H&N over the .250. It was pretty apparent with the first shots at 50.

I have 2 for sale. Ideally would like to trade for 25 cal mags. Otherwise, 45 shipped each. One sold! One more to go!

Pyramid has the specs I found. 22 - 100 FPE 25 - 120 FPE 600cc at 310 BAR 250cc Plenum Cool gun for sure just way too heavy for what I use my impacts for.

Curious on the FPE these can attain.

My 25 cal FX seems to prefer the .249 in 40gr.

Pushing your front reg up to 180-190 will help refresh rates. I’m roughly the same but using a tungsten hammer and 700MM.

So I’m gonna start my own testing in 25 cal, shooting slugs at 900+ FPS. The reason I ask is because I’ve watched a fair bit of the RMAC videos and the North Eastern Airgun Comp. From what I can tell, the guys shooting bench test competitions are still shooting with the factory shroud. I...