ScopeFX's latest activity

M3 600MM at 125 bar 2nd reg likes to shoot them at about 880. 900 FPS wasn’t bad, but wasn’t at good further out. Would shoot them 930...

I will have a slug barrel as soon as they are available and can do a step by step video or something.

Would like to see the slug kits for them if they come out.

You’ll need a “porter” to hand you the gun prior to your shot. She is a very heavy girl…

In

If your slug diameter is too big, it can cause an ES issue.

There is one other explanation, but only if your groups are less than ideal. If this is the case then too much air, if not the case...

I'd say even higher honestly for a tighter spread. Some guns like to be closer to set point for better consistency. Doesn't hurt to try...

Those were NSA 38.5gr

Glad you had good luck! I need to try the .250 too. My Impact seemed to like the .249 from my initial testing.

Somewhat struggling getting the SD/ES to tighten up. Info below. My pellet M3 is in the single digits but this one is hovering a bit...

To my knowledge there are not magnets that I know of in the M3 at all. But, wait for others to chime in as it is a medical question.

I’ll try and document my barrel findings. Have some NSA and Javelins on the way. But also ordered up .249 and .250 of the same grain. I...

My M3 likes the .249 H&N over the .250. It was pretty apparent with the first shots at 50.

I have 2 for sale. Ideally would like to trade for 25 cal mags. Otherwise, 45 shipped each. One sold! One more to go!