Recent content by Rowdy_1

O-ring glue = super glue Due to the clearance between the cup and the body you would have to have an o-ring with a very small cross section which would make it hard to work with and with a larger cross section it would tend to roll to the inside of the cup (creating the same problem as the...

I made a new limiter the same as you did but still had problems with it slipping into the grease cup. I found that a Dash #021 Buna 70 X-Ring fits the bottom of the grease cup perfectly so I used o-ring glue to attach the x ring to the top of the 1/32" thick buna 40 disk that i made. This has...

9 hrs. & running good.

Alone, except the rare occasion I can get one of the kids out of bed early enough on the weekends, the only time i have to shoot. Nice cool mornings are the most enjoyable.

I use a portable power station to run the AC supply. I am only seeing a peak of 371 watts on the AC side when filling 700 cc from 2000 to 4500 psi. Just throwing this in as I'm not sure if it matters which side of the power supply you get the measurement from.

Target Forge is carrying an updated board & is making adapters to make them fit.

After pulling mine apart I have found that the membrane is working as a diaphragm so the screw forces a little grease through the hole in the membrane then a small amount of air pulses the membrane working the grease to the larger hole in the body where it is pulled into wherever it needs to...

Maybe an O- ring with a small cross section on the grease cup below the threads. I will have to take the cup out of mine and take a look when I get some time.

I just got mine recently, will have to keep an eye for the deformation. thanks for the explanation.

Something I found when researching this compressor may be of interest. Its explained in the small print below the pics. https://blog.roninsgrips.com/the-cs4-grease-pot-how-to-add-grease-to-your-compressor-and-refill-the-pot/

Way less than a year, CS4 Compressor arrived today.

Hello all, found quite a bit of useful info lurking around over the the last couple of months so figured I'd join and see where it goes. Bought an S45 and a portable yong heng compressor (YH-QB12-S) to start with. Enjoy plinking with open sights but will also use for occasional pest control...