Recent content by RonCotton

Yeah bud if a little heat didn't get it to break loose you may be better off just trying an "X" reg. I've seen on a lot of other threads that people with the original avengers were switching over to the stainless "x" version due to build quality of the older brass ones...?? and due to reg creep...

Alien Airguns and Bargains on eBay has both available i believe, the bottom 16cc version and side mounted 18 cc version. Top notch quality and service from him as well!!

I know its a few months later but i just tore an old creeping Avenge X reg apart for the first time and it doesn't seem your question was answered so hopefully this helps. After using some snap ring pliers to remove the cap the Belleville washers should just slide out leaving the brass tube...

Old thread but happened to see it. Orcair does make an M8...at least now not sure when this thread was fresh. It's on Airguns of Arizonas website for under 50$ I think. It's cr2032 operated tho. Honestly I could care less about that versus rechargeable but I read somewhere that you have to...

I was looking at getting the side plenum but you couldn't get them in the states at that time and it would not fit in the classic stock with out modifying the stock in a very visible location. Being fairly new to PCP's myself I opted for the "out the bottom" version which was stupid easy to...

Sorry wrong one. The m8 one is on airguns of Arizona. 28mm omega digital gauge

Amazon has one.....I haven't tried it but was thinking about it after I financially recover from the custom carbon shrouded 24" Lothar Walther barrel im waiting to be delivered..lol

You weren't lying...lol. thanks again!

Awsome! Thanks bud!

Firewalker, I tried to send this in a private message but it would not let me. I was just curious how you removed the piece from you stock (the bar that goes from the bottom of the grip back and up to the "tube"? Did you simply use a hack saw and sand paper??. Love my notos but not a fan of...

IN