Recent content by RodrigoR

Hi, I fix it on my own. This noise comes from the air escaping through the hole where the valve pin slides. After several tests I found a balance between pressure and hammer. I'm currently shooting at supposedly 150 bar, generating a power of 57 fpe. At first, the hammer adjustment doesn't seem...

I have an Auragan 2, what caught my attention is the fit between the block and the barrel does not have any type of seal, it is direct contact between the metals. On my own, I applied a thin layer of locktite to try to seal as much as possible.

Friend, I have an FX maverick .25 and a uragan 2 .22 and I can say, the FX benefit from a barrel fixer, even though it is not recommended for precision shooting, however on the Uragan 2 the barrel does not move. You should worry about how to tune the regulator and hammer spring, as it has a...

This was the best I could do after thousands of shots

This is proving difficult to adjust. I installed a human air regulator, it is at 150 bar, with energy of 57foot-pound. The spring adjustment does not change power, but it may reduce the spread a little, if I leave it close to the block the spred reaches 30, with an ugly sound, it sounds like a...

I have the African Airgun upgrade kit, but I didn't install the stronger spring, would it help?

Thanks, I'll try,

Note that with 4 and a half laps I had a spread of 9, but after continuing with the tests, when I went back to 4.5 I had a spread of 21. Nothing seems to follow a pattern.

Hello, I did some tests with the spring adjustment but it doesn't seem to have much effect. Follow the data Uragan 2 700mm .22 huma air reg at 140bar slug 29gr .217 The top number is the weight of the slug, and the bottom number is the number of turns from the bolt flush to the block. shots at...

Thank you, I will wait. The seller is an importer, he does not have technical assistance to resolve these problems.

I bought the upgrade kit from them, I only installed the depinger

I already sent it, but I didn't receive a response.

Hi, I have a Uragan 2, 700mm, .22. When shooting I feel a noise, a loud bang, very loud in my ear, to the point of bothering me. Associated with this, I feel a jet of air coming out of the stock. I've already checked the position of the barrel in relation to the transfer port, I've changed the...

I bought the Africanir upgrade kit, I've already installed the depinger, the stronger spring and the longer hammer, should I increase the pressure on the regulator?

I opted for the 700 and I already have it. I haven't shot in the field with it yet, but I took measurements at home with the chronograph and it even reaches 805 fps with the Knock Out Slug .22 26gr.I thought the speed was low