Recent content by reprobate

sorry if a stupid question, whats a reg tester for ? saw it in the parts section whi;e looking for extra mags

My battery charger of the redwolf just gave up on me :( what are my options for a replacement ? do i have to go oem or can i use any other with a better build quality? any suggestions would be helpful .tia

well done sir

Thank you Bob. You were of great help. degassing worked like a charm !

Thank you very very much for your help. All done ! could not have done it without your and Arzover guidance. The o ring was there. Its seems so simple now... after the event hehehe do you loctite the 2 screws in the end? 

in the redwolf breech assembly diagram, there is a part under the steel cup, #13 ? is it an oring ? i dont see that in the parts that came out? 

would you happen to know the size of the oring there? since its already open, might as well replace it... bagnall and kirkwood have them but @ 17.50 GBP a piece if i remember right

Daystate was great, they sent me 2 free of cost. one for the broken one and one for the safari, just in case. my pin was also found stuck to the single shot tray, i exclusively used the single shot tray. so would like to know too if its the tray issue? never used my mags. one more thing, on my...

Thank You !!! Bob. thats a relief. shall give it a shot in the morning ! thank god for these forums, they are a blessing for an old dog learning new tricks ! :)

Hi, Need help. I managed to open up the screws and took out the broken part but I cant get the cup back in the hole. It only goes in about half way... what am I doing wrong?

i got no reply from fxusa but preordered from holland

Thank you very much ! this was a big help

hi... i have one of these on my impact. the parts list (B29) says all 4 orings are 10.5 x 2 mm. but the bottom oring in this picture .. i cant get it into the tube to screw in... it just wont go in the tube? is the last oring a different size ? any suggestions ..... im stuck. thanks all

2500

thank you sir