rdpjr6504's latest activity

When my .22 707 check valve went up it deteriorated and debris was thru out tubes. Had to disassemble to clean and did a reseal at same...

Yes thank you I just looked and saw that. Did not know as the ones I have from PYRAMYD AIR are not one way. HIGH PRESSURE PNEUMATICS...

Even replacing the fill valve will not correct the leak. It seems to me it is the check valve has deteriorated inside the tube...

Yes whem tank is empty you should cock the rifle before filinf if not hammer may hold valve open and leak. The image I attached is a...

me Air Guns Accessories PCP Fittings & Adapters Quick-Disconnect Male Fitting + O-Ring Quick-Disconnect Male Fitting +...

After vooming in on your image looks like a lot of crud in the end of the port for the check valve. May want to try to clean that out.

The check valve is in the rifle tube under the fill probe part. Try a couple drops silicon oil in the hole in tube then refill. Might...

It could have a stuck check valve in fill adapter. Try some silicone oil in fill port whe filling may loosen check valve. If not you...

This listing has been renewed

This listing has been renewed

Barrel is 15mm see images. I put o rings on barrel and slid carbon tube over them. Carbon tube is 17mm inside by 19mm outside. Let me...

I will measure when I get home from work.

Picked these up on forum used. Pretty sure the seller stated they were REDCORN.

Or ALIEXPRESS has them also. Get the 500mm length

I do not remember the size but ordered a while ago from Amazon or Ebay.