rcs9250's latest activity

That’s cool, a bar stool inverted to hold tanks. Very clever. 👍

This may have been mentioned in replies to this thread as I have not read them all. A well known member on AGN PM’d me regarding a PCP...

Got to thinking and looked at my other Aluminum Tank and removed the knob. Same basic connection. Drove to local dive shop, and owner...

When I worked in a dive shop, inspecting scuba tanks was a daily task. We had a long 1.8” diameter (3.18mm) pick about three feet (1...

I needed something funny to read this morning. If you want to shoot bench-rest... take anything you have that shoots... plop your butt...

I don't think the word inexpensive and benchrest work together!

Common sense is probably your best safety equipment.

The only risk I worry about is operator error. The equipment might break and vent air in an unexpected manner but mine has not. I...

Yeah, eye protection should be mandatory. A dive buddy that worked the same dive shop that I did once attached a low pressure hose...

Probably doable since a ton of youtubers in the powder burner sector wear tactical helmets, plate carriers and othe tacticool stuff to...

Tiger Shark all the way. I owned both that the OP mentioned. Joe B tank throttles very nicely because of the slow fill from tank to gun...

I went through a whole lot of PCP’s in past two or so years. If I knew then what I know now I would buy an American Air Arms .25 or .22...

If my brother asks a question and the person responds “I’m not sure” he says “So you don’t have a f’ing clue right?” 😂😂

Unfortunately I know longer have the compressor nor any photos of what I did. Sorry.

Your post says an 88cc tank. If you’re losing any air while connecting any fitting I think it could easily drop 500psi. But if you meant...