Ratzy's latest activity

It does use back pressure to close the valve. I replaced mine. Best Fittings in the UK...

Killers…

Well, no adding plenum to a G30. That little 1mm hole makes a right turn in the block. The gun has a small plenum and given it is a...

Glad you found most if not all. I have a Tuxing dual cylinder awaiting the rebuild kit.

After 45 years I'm still happily working as an Engineer. I much prefer my low voltage to household. I've always been able to find the...

For a 9 year old weight and cocking action are critical. Look to the pistol/carbine PCP rifles like AirForce Escape UL, light weight...

Hey Everybody, I've suddenly discovered air guns and they have my interest peaked! I do a lot of shooting with pistol and rifle and am...

Soooo deep, You can’t see the bottom. Welcome

Yeah, finding holes through 2 1/2" particle boards was a surprise. Aluminum plates for me.

It worked on the fridge 20a until the fridge kicked on. I didnt see it was ever on an isolated 20a.

Hrmm, you said it perfectly.

There isn't a lot of difference, but there is a lot of folks who would like to think so. They want to sell air rifles, and they want...

Most of these compressors are 1800 watts. I=P/E 1800/120 = 15 amps If your voltage drops below 120 the current goes up. Weather has...

It was supposed to be a dedicated slug gun with impressive amount of power. Factory regulator setting ~190 bar it is mundane. 220 bar...

Shin Sung Hunting Master AR-6 .22 With the pad out from under the pin where the hammer hits: 900FPS. With the pad: 600FPS