Recent content by rash_powder

How necessary are the water/oil filters like https://www.amazon.com/TUXING-Compressor-4500Psi-Molecular-Separator/dp/B07Q221JFX/ref=psdc_3753811_t1_B07NQ8X9PJ or...

I see that this has been asked before, but I just wanted to get a current vote for where/what vendor to get a legit YH compressor from. The only reason is i've finally saved enough to purchase one and being the cost is, at least for me, significant; i don't want to get hosed. Thanks all!

On rimfirecentral, they host many different shooting competitions/challenges. Its all on the honor system for rule following and such, but it sure looks fun and those who participate in it do seem to enjoy it. Is anything similar hosted here?

I'm not sure how much aluminum is in the various air rifles around, the couple pcp's i have make it seem to be the metal of choice, so this should be of interest/concern to most. Graphite and aluminum do not get along! The two materials will cause galvanic etching/corrosion. That said, I...

I may be a bit behind - whats an MRD?

A little extra mass is not always a bad thing. I built a super lite 10-22 that is too lite to hold steady. The mass is what your muscles work against and there has to be some or there’s just no resistance. I am hoping to see a few more reviews before I make a decision. Hopefully it works...

1977.05 thanks for the opportunity!!

Everything I have read says 800-950 fps. I imagine it depends on your elevation to avoid trans-sonic speeds within that window. ...

I finally got back to working on this after nearly a year - things move slowly for me. This pandemic and home life are taking a tole. I have hit a wall and am not sure how to solve it - I think I have an idea or two, but not 100% sure as to the proper route. I have, through regulator and...

Hello all, I was adjusting the power wheel on my Talon P powered off CO2 the other day, and found that as I increased the pre-load from the default setting, I didn't really gain any velocity but my extreme spread got smaller and smaller. I've got to say, I was expecting the velocity to...

No, all good info. Thank you much for the pointers. A while back I found an exploded diagram of the pistol and ordered o-rings. I have something like 20 complete rebuilds worth of o-rings now. I was going to just replace all the prints, but will definitely inspect that one under the...

Sweet! What you said verified what i was thinking and filled in a few bits I hadn't thought of. I know a complete disassembly is in order, but it is needed as I lose half a 250 bar fill overnight. thats a lot of pumping for naught! I have seen in another thread that Thane polished his...

I finally had time a couple nights ago to shoot my PP750 over the chrony and get some data so I can start to tune the pistol for max shot count. I'm shooting 5m at paper in my garage and would like to see how many shots I can get from it. Below are my shots, all in one line. They were done in...

 Bambuino- below is the shipping list from the O-ring store. After considering the minimum quantity for the different part numbers, I think I ended up with enough for twenty rebuilds. That’s for normal people, for me that’s about 10 after all the screw ups. I think it was right about $40...

Bambuino- I got the exploded print/parts list and ordered all the o-rings needed individual. No kit that I’m aware of. ctshooter- I did notice while degassing that at some point the pistol did just totally exhaust itself. Has me a bit concerned about refilling it now. I ran into a bit of...