Recent content by rappert

This listing has been renewed

This listing has been renewed

This listing has been renewed

This listing has been renewed

Bushnell 4.5-18X40mm scope. MOA. Min. Parallax 10 yds. Scope mount not included. $155 shipped to the 48. Paypal f&f or Zelle.

24.8 gr. 0.217 Nielsen slugs worked for me @ 1120 FPS with a tensioned barrel. Orange pasties are 1". Impact MKII / 700mm barrel - standard liner (not slug liner).

I had a similar issue with a new human reg on filling VERY slow set at at 170 bar. I contacted Huma-Air and found out that there had been a revision on the number of Belleville washers that are installed for that regulator (1155). Mine came with nine and the instructions showed to use all nine...

See pic. See pic.

See pic.

No, the barrel end where the holes are drilled to reduce the weight. Thanks.

The width of the hole section. thanks.

Can someone please tell me what the thickness of the AirMarksman Backbone is? Not the wider part where the rail is, but the part where all the holes are. Thanks, Randy

Make sure your air valve closes before the projectile leaves the barrel.

Machined a spanner wrench to take the valve off my FX bottle. Worked real well.

You definitely need the tensioner on the 800mm barrel in .35 Cal. especially if you are going to increase the power. The Power Block will buy you a little bit, but its gain can be made up with a higher reg pressure unless you are going for a very high velocity then the PB would pay off. I have...