Recent content by PlinkForFun

Actually, i got one off of SMW engineering and was actually just what i needed. Thanks though guys.

Hey guys, does anyone know where i could pick up a picatinny bottle clamp for my dreamline with an aluminium bottle? Im hoping just for a simple, cheap 3D printed clamp of sorts for my bipod. Ive seen several, like the ohio airguns one, the JB3D one on ebay from the UK, but i just havent heard...

It could be an optics issue. I tested the vertical and horizontal tracking, and both were good, but for the last 2 turns on both dials is where the reticle stops moving. I repeated it a few times to make sure, and that was exactly what happened each time. I had my vertical dial almost adjusted...

I have an old Simmons 44 Mag 6-21 x 44 and it works great. Clear glass for an old scope that ive used on some of my firearms. I havent ever have the reticle stick on me though, but otherwise, it has tons of adjustment, finger adjusting turrets, and parralax down to 15yds.

Also is a copper brush all right? I have a .22 copper brush, but its pretty stiff and hard but im not sure if it will eat the barrel or not. I just cleaned out the barrel last night with a few passes with a nylon brush, a few wet patches with hoppes #9, and a few dry patches, and then a few...

This also might be it as well. I do have a plain old superior barrel with no CF liner on it or orings either. I was planning on getting the FX CF liner things when they come out. I will try out pellets here in a bit and see what happens.

This could quite possibly be part of the problem. Ive noticed that occasionally when i adjust the turrets on my scope, my POI stays the same, i was never sure if it was my scope or the gun, but now I know. Will over adjusting and then fine tuning it afterwards help eliminate that problem completely?

Yes i believe it is for at least the dreamline. I have a .25 and converted it into .22 using parts I ordered. You can go through FX’s site and look through schematics

Oh, good idea, i havent really bothered to look at the crown and ill see about some bore polish too

Ive heard about this one, ive been tempted to get it, but ive also heard bad stuff about it. and also about leading, i just went and thoroughly cleaned my superior barrel, and went through about 2-300 slugs in the past several days, and the patches came through as barely even dirty. The...

Yep both the grub screws for the barrel and TP, and scope mounts are all properly snugged down. If i could, i would use a barrel band, but i have the bottle version, so the shroud isnt able to be properly held secure, so ive been shooting without a shroud. Using no shroud definitely helped with...

Hey guys, so ive been doing lots of tinkering, and i got my gun to shoot great groups with some NSA 24.8s in my superior, but the POI is CONSTANTLY MOVING, but as it moves, the groups stay tight. I literally leave it on a table inside for an hour, and go back to shoot it, and its changed. Go to...

Try this site. https://spares.bagnallandkirkwood.co.uk/air-arms/air-arms-s400-s410-s-400-410/ they have schematics for the S410 and have what it looks like the o rings and seals you need. 

Oddly enough, the liner is straight, but i will try indexing it and more tunes and ammo to see if that helps.

Hey guys, i bought the last of the slug A liners in .22 a while ago, and i just got around to using it a little bit, and it shot way off target. I noticed when i was swapping barrels that my slug A liner is shorter than my superior liner that was in the gun. Both were supposedly 600mm, But...