Recent content by pikerf

Im going to work on a redisigned tune tomorrow. Order parts monday. Love working on it anyways. Thanks

yes thats right oops

Thanks airgunmann, ill raise the reg 2 to 80 , lower the hammer to get velocities down to 900 and turn in the valve til drops another 10 to 20 f/s for good groups

Ill try that. How far can you turn in the valve in? Damage anything? When I did a shot string with the valve at 3.8ish my numbers got worse. I settled on line 4 9.30mm from the collar and micro 2.25. es 5 sd 2 889 f/s average. At line 4 all is good its an issue passed 4. Over 150 shots once...

ya the issue is just during tuning when the valve is opened up to achieve top velocity so I can subtract the 4 to 5% to be on the knee. The micro is at 2.25 minus 1 or 2. best accuracy was acheived at 4 lines. No Issues then. Great numbers and 1 inch groups at 100 yards. Im assuming just the way...

great ill check it out. thanks for the help

ya been looking at gray allen keys but hard to find a kit with a 1.27 mm in it and ball end

Ya never had the second reg passed 80bar or fired with no air so I shouldnt have any damage to the valve. I have tuned the 15.9s and just got the 18.13s tuned. Next the redisigneds before slugs. Ill see if the added reg pressure helps. Thanks everyone, thanks for the link heavyopp.

Im from canada. fx usa will redirect me. Maybe ill try sweden, 70 bar is what is recommended for the sniper in.22. and i agree second reg closes te valve. heavyopp , your link is pretty much whats going on. ill finish the read

Call fx sweden?

Searched for a thread with no luck. My issue is during tuning. Once the V.A is set at 4.5 to 4 lines I have no issues. During tuning with the valve passed 4.5, sometime wont seal once the 1st reg gets to 160-165. First reg set 150 2nd 70. I can just tune til the 1st reg gets to 170 but Im...

Great info. Such a big help. Wind would blow my 18.13 out of my impact sniper all over the place. Thought that was just the nature of the beast. Purposely went out today in big wind to see if I could get better results. Started from scratch and used your technique. By the end, a few less on the...

is the dust cap still on. It shold be . It stops the probe from going in too much or too little

FYI . Took it apart and yes more rubber in the hole. cleaned it up ,made new oring. holds air and shoots awesome again

A little history first. Scratched the inner wall where the valve holder sits. Had to sand out the scratches but now the stock orings around the valve holder dont seal. I now sand my own orings to fit. And it works, holds air. Was shooting 18.13 g at 890. Degassed the dreamline to lower reg...