Recent content by piinnh

Reduced Price many accessories included Brocock Bantam Sniper HR (Huma Regulator) in .25 caliber, synthetic stock w/ these accessories... 1- KOI Donny FL Moderator 1- 3-10x Accushot rifle scope w/Range Adjust Ez wheel 2- 10 shot .25cal magazines 1- single shot .25cal tray 1- kit of maintenance...

Reduced Price many accessories included Brocock Bantam Sniper HR (Huma Regulator) in .25 caliber, synthetic stock w/ these accessories... 1- KOI Donny FL Moderator 1- 3-10x Accushot rifle scope w/Range Adjust Ez wheel 2- 10 shot .25cal magazines 1- single shot .25cal tray 1- kit of maintenance...

2334.18

L.Leon Will do, I have included the instruction sheet they sent today.

I have both unregulated and regulated. I enjoy shooting both but I pick up the unregulated more often because it is smaller and easier to hold free standing. I use the Marauder Pistol/Carbine to shoot squirrels, other pests and target 30 yards and closer. It is a non-modified8o air gun that...

I try to get out daily when my back allows. I shoot a 20 bullseye benchrest target at 30yds with my Marauder Pistol/Carbine. Photo attached I take my Bantam Sniper 25cal to the range and shoot 50 and 100 yds. Had to drop archery and air gunning is a blast. Having trouble finding pellets...

Update and a good one. Emailed AOA and explained the problem with the fill valve on my Bantam Sniper HR. The AOA service department got back to me and said Brocock have designed a new fill inlet valve and will send it to me free. I also enquired about a Inlet Valve Removal Tool and they told...

Scott, Thanks, after now 4 back surgeries I have learned to listen and take it slow. Besides last time I got frisky my wife threatened to break my legs and she's a nurse..... Chase

Thanks again everyone. After reading the posts here and following the link to another thread, I went to the gun cocked it left the probe open and the gun took air all the way full. Not sure what really happen.... I am going to buy a new fill assembly and ring set to have as backup in case...

Thanks everybody, Will call AOA and get their idea of how to handle it. I am sure Big Tin Boat is right about the check valve being stuck. Ill update this thread with what AOA suggests. C

Yes, I have the extension and there is no sound of air escaping from anywhere.

Thank for replies, I guess I did not explain well enough. My charging tank is fully charged at 4500 psi. I connect to fill port on gun and needle on charging bottle/tank jump to 200 bar like gun is full but it has no air in it. The gun is not taking any air. I have not tried a hand pump...

After not having used the Bantam Sniper HR for a long time because of health reasons I found the gun did not loose any air pressure. Thats the good part. I took it out and shot it until it was just about to go below the 140 regulator setting. I refilled it from my tank but it did not take a...

The Prod is a fun project, so thanks for posting your strings. Having had an Mrod and installed a regulator and played the same game, when I got my Prod I decided to keep it all factory. I have been having a blast shooting more with the Prod in my backyard than my other airguns. Good luck...

Wiseguy, Nice setup, wondering where you got the raised cheek piece on the stock? Is it stable enough to not move around much? Thanks C