pattedog

Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)
  • Views :
  • Link

    pattedog
    Participant
    Member

    I eyeballed mine and then I tested the rifle in ”house” shoot it at 20, 30 and 50m just to see that it was aligned with scope. Otherwise a barrel laser or what they are called would help

    AA S510 Xtra fac 

    Link

    pattedog
    Participant
    Member

    Mine did before the reg between 820-892fps with jsb 18. Now with the reg i have 872fps.

    but I use AA 16grain and with them I got 928fps. The reg is set at 145bar, Took it a little higher because I will wait with hammer mods, so its quite loud now, 101db 

    Link

    pattedog
    Participant
    Member

     

     

    Have a S510, now regulated with a HuMa reg. 

    Did this today, 7 shots at 50meters (55 yards) just a little wind today 

     

    Link

    pattedog
    Participant
    Member

    But does it still waste a lot of air if i have the regulator at 145bar, anyone tried? Otherwise is it 135bar and lighten the hammer with about  10grams? of course, every weapon is a little different from each other

    Link

    pattedog
    Participant
    Member

    Updating this thread a little.

    I have an AA S510 .22 fac and thinking about install a HuMa regulator. Have yours working fine since they got installed? If i dont do any more mods than the regulator, should i have it on 140-145bar, or does it waste a lot of air even on that pressure?

Viewing 5 posts - 1 through 5 (of 5 total)