Recent content by PaniSd

Hi to all, I done all I can to provide best service for all of you who trusted in me and my kits ... and will do so always to support any problem it might occur in the future to. The bad time come and with covid and I was straggling to maintain shipping as it was before. Post first didn't...

Here is a new video ... shooting .30 50grain below 100bar above 900fps ...👊👊👊 https://youtu.be/NCJLC2pndFw

Thank you all for good words... new upgrade test is perfect. New video within next day... stay tuned 

@edosan ... thx Those 160fpe is in .35 ... cant wait for it.

I believe after some time I would like to say something about my work around Fx Impact gun and modifications I made for getting best of it. I hope this is not against AGN Forum rules … then I apologize and pls admins delate this topic. As we all know Fx Impact is quite a unique gun and about...

Maybe go a bit more on reg pressure to get all on a bit more 950fps for example. Use the valve to find a good speed for accuracy going down from 4 lines. What is called sweet spot is the point where you reach good accuracy with low spread in fps. Im now on 15mm hamer 960fps 125bar and gong...

With my .30 and 59grain JSB ... with ext plenum and all the mods ... 125bar 960fps easy... you do something wring. Need to go back and start agin.

I have same expiriance with slug liner 600mm in .25. I compered those liners and slug liner was spot on with 34grain Jsb ... grups much beter than pellet luner. 20 targets on 100m ... all of 5 shoot groups was between 1/3 of inch and 1". That I culd not make with pellet liner

I have no words foe such honest review and its for sure the best one I so. Thanks Edosan ... as always you master it 💪💪💪

48cc and 63cc ... new development will be posted soon

@bzizzi373 Thats what you do after you index your barrel ... or you didnt get the point of barrel indexing.

@Max115 Thanks for making cideo and sharing your impresion about barrel indexing. Im happy to see more and more people are seeing advantage of it.

Ok nice ... next thing Im goingbto do. Thx

If you have all of this mods ... it shuld work. One thing to start with ... I recomend you measure your plenum volume. As I do power kits to, the only thing I can think of is plenum volume since this looks like my experiments with plenum volumes in past. In .30 all my kits do 125 - 130bar...

Rear block hole is 7mm and if you do VH like that, there wont be tu much benefit due block hole is smaller. Im waiting for my new block that I will try to enlarge block hole to mach VH hole in that size that I belive .30 will have bigest benefit.