Pale_Rider's latest activity
Pale_Rider reacted to Texas Iggie's post in the thread American Air Arms Any skilled machinist out there? with
Like. That sure is what caused the damage. If you cant get a replacement lower from him then send me a message and I can make the lower for...- Pale_Rider reacted to Texas Iggie's post in the thread American Air Arms Any skilled machinist out there? with Like. There is a good chance the O-ring got cut at the port when the valve was installed and is the first thing I would replace if you want to...
- Pale_Rider reacted to Airgun-Revisions's post in the thread American Air Arms Any skilled machinist out there? with Like. Show a pic of the side of the brass valve that made the damage. Just below the TP. I’ve seen this happen before and it’s usually due to...
- Pale_Rider reacted to Hubenairgun's post in the thread Huben Huben Pistol GK1 Mini - Available in August 2025 with Like. Model: GK1 Mini Measurement: 26.5 x 16 x 5cm Weight: 960g Barrel: 15cm Cylinder: 49cc
- I let these three shine along with the sun today. ☀️
- Gave the Daisy Powerline 44 a trip to the range today, not particularly accurate, but it's nice and smooth to shoot. Only tried the 4"...
- Right by the action, I use low temp alloy while I had it together with the action and an alignment mandrel. Then cleaned up on the lathe.
- I have been focusing on CO2 airguns lately since it's been warm. Shoot this 2 stubby, couple of hundred each, before working on the...
- Neko was Barking at the Door…I hear… “Knock Knock”…Who’s there…It’s you Lady USPS Driver…I have another Gun for you …Do I Shoot First...
- Today i shot a Webley Hurricane .177 and tried an old tin of Eley Wasp pellets . Wish i could get my Iphone cam to Email to my PC to...
- Today’s choice was the Crosman MK1 in .22cal…I replaced a few seals last week and did a quick test shoot…it all went fine …today’s test...
- Got my lefty breech last night and cut it down this morning. Shot it to re-zero the sight. After this I changed grip on the Twinmaster...
- Pale_Rider reacted to Ranchibi's post in the thread N/A Taipan Vet 2 after market parts and servies with Like. I recently sent my Taipan Vet2 to Tony of Talon Airguns (used to be Talon Tunes) for a cocking issue (probably the only Vet with this...
- Pale_Rider replied to the thread Huben Any issues or problems with Huben gk1 please share your experience.Huben made this pistol with the intention to shoot pellets. Pellets would not fit if the mag chambers were small enough to fit .177-.178...
- Pale_Rider replied to the thread Huben Can you put a red dot on a Huben GK1.The mount from redotmate perfectly fits the rear sight recess and is rock solid with no play. I tried a 3d printed one that was...
