Recent content by OC_

These dont look like quality prints nor like serious ammo.

I did this chassis for my out of control 177 avenger project.

You may not be far off. They make special 3d printing filament for investment casting. If you are familiar with the process, it works just like normal. I dont think anyone has ever investment casted ammo before... it would be interesting.

Usually the port its going into just has a sharp edge.

Really nice. your printer must be huge!

Are any of these guns in the 350-400 dollar price range anymore with these tariffs?

I have one of these ready to go if anyone is interested.

104% tariff.

I picked up a cheap no-name compressor from amazon last may for $168. Its works really well and looks well made. The power supply went out in it recently but that was an easy fix as those power supplies are sold on amazon as well. I looked at other pumps to see what's out there and it looks...

Yes, it should fit any big bore bullpup that has a shroud.

Here’s the package.

they are Dales. They were not a normal order. If you talk to him, he can make you anything you want. They actaully measure .1765 on my caliper.

they measure 177 and are actually 12gr. its been so long since i looked at the package i forgot what i had! I do run those with the factory barrel and they were a no-go.

1:16 barrel on a gen 1 avenger? That doesnt sound right. I would guess more around 1:24? I'll put the caliper on the slugs i have from Dale to see what they are. It was a sample pack iirc.

I have never been able to find what the factory barrel twist rate is. Do you have a confirmed source on the twist rate? I have tried Dales's 177 slugs. I have some 13gr ones left over im going to try in the FX liner. I have also tried some griffins, nothing over 10ish grans worked. The only slug...