Recent content by nivlag

1849.59

2183

Leatherman: Thank you for the info. I think that I will leave the gun alone and do like you suggested and figure out what holdover I will need for that target.

Felix: Thanks for the in put. I have not seen any lighter pellets than the 44.75 for my 30 Cal. Have slugs that weigh the same as the pellets. Will have to look for how to increase the pressure and the other things you have suggested. Thanks

I think that what I am looking for is how to get more power so I can shoot further with less hold over.

I have a FX Dreamline Classic in 30 cal. and would like to see what it would take to increase the range beyond 100 yrds. I am shooting JBS match Diabolo 44.75 grain pellets for now.

I am new to the casting of pellets. And was wondering if there is a need to preheat the pellet mold and if so how do you preheat them??

Thank you for the information.

What would be the chance that the use of a soft aluminum for pellets or slugs? Just a thought for another alternative to lead.

My problem is I am coming smaller than the caliber size. instead of 7.62 mm or .308" I am getting 7.56mm /.295". And what I was wondering was will they still shoot ok?

7.62= .30 cal

I am a new to casting pellets/slugs and on my first try using an accurate 30-50 mold and my first casting my pellet/slug are measuring 7.53/7.58 mm. on the rear ring. Is this ok to shoot? Or are they to small to work right? Lead temp at 620/650 degrees. The mold never got over 175 degrees. My...

$2195

Thank you all for all the good info. I ordered some from Amazon on Thursday and got them today.

I bought this scope new put it on my FX Dreanline classic sighted it in and then decided it was more scope than I wanted for type of shooting I am going to do.. So I took it off put it back in the box. Comes with original box and all the paper work. Asking $90 shipped to the U.S.A only. PayPal...