nervoustrig's latest activity

The opposite of each...it would need either more hammer spring or a lower regulator setpoint (or both).

A (mostly) complete list of things that make it easier to reach the velocity plateau, in roughly ascending order of...

Try David @Rocker1

Just want to say I can’t recommend strongly enough to try a mirror to mount the scope. Why? Well I guess it takes no convincing that...

I always level my scope using a mirror. The line of the elevation needs to be centered to the bore. If that is done, mount a level that...

You’re pouring the molten lead onto a jag (or similar thing) at the end of a cleaning rod. After it has cooled, you apply abrasive to...

Hi @Ezana4CE, in case you hadn’t run across it yet, here’s a link to the thread where Dillon reworked the crown on his Taipan...

Considering how many funky extruded O-rings I’ve replaced over the years, I will freely admit my instincts were that an O-ring is likely...

I would place the odds of a mid-barrel choke being intentional at 1:1000. It represents an unnecessary complication in the production...

Good job! You, like me, get your money's worth out of your mini lathe! Ive seen that more than a couple times on factory threaded...

Swings and roundabouts, regs recover quicker with bigger pressure differential but also suffer more wear to the sealing surfaces and...

This is the setup we will be shooting at worlds for 50m unlimited. It works. 😀 Mike

Since you have an AT44, I'm gonna suggest you shoot HN pellets, or JSK KO slugs, even Zan slugs. I used to have both an AT44 177 pump...

Fill port check valve.

Many PCPs have a way to adjust hammer spring tension on the fly. Doing so will change valve lift and dwell to be more suited to lighter...