nervoustrig's latest activity

Shot my USFT last weekend at its second match as a .20/Hunter class. This was at one of Garrett's monthly matches at Rio Salado. Been...

Given the current state of airgun design, I really don't think there's a major difference between the two. There are plenty of HPA...

These are a couple of my favorite “Cheapos”. With a little TLC they perform well above their price point. Kenny

Just a suggestion based on my experience. I was in the habit of using a -010 O-ring in the female connector of my various fill whips...

Like Scott said, running a QB79 on air can be as simple as threading on a Ninja paintball tank. A good place to start is Bob’s...

I use grass trimmer line in the green colour for .177 . Cut to right length, heat up one end with a lighter and flatten it out. Cut the...

Burst disks flex every time the gun fills and empties. Over time this can fatigue the metal and the disk will rupture, even though the...

Yeah, this sounds like a job for the Bridgeport. I suspect most of the wear in the hole is toward the rear and downward, where it would...

Agreed, a bushing is the best solution. Execution is key, of course...do your best to get the bushing centered on the original pivot...

You don’t know that I don’t have it. Maybe I do, I have lots of stuff and spend way too much. Glad you where rude about though, that...

My MKI did that years ago. I pulled it out cleaned it up on my lathe and it's been good ever since. It seems like I came to the...

Thanks for the pic. I agree the amount of sear overlap looks similar to how far the indentations extend from the edge of the hammer...

It looks more like impact damage than wear against the sear. Is there something in the hammer’s runway that it could be knocking against?