nervoustrig's latest activity
nervoustrig reacted to Trucker3573's post in the thread Tuning Regulator pressure VS Hammer Spring tension with
Like. I’m not really familiar with that system never having owned one but I believe with hammer throw you would be essentially achieving the...- nervoustrig replied to the thread Brocock/BRK Ghost regulator not holding set point.Dressing the seat surfaces is indeed the way to improve it. It's actually not that bad, though, A decline from 124 bar down to 114 bar...
- nervoustrig reacted to Franklink's post in the thread Marginal gains and barrel/projectile choice with Like. In our FT game, the ability to address the wind at the time of trigger break is usually what separates out the field. BUT starting with...
- nervoustrig replied to the thread N/A Tuning a Regulated PCP.Either way will work in most cases. The initial goal is just to find the amount of hammer spring tension necessary to reach the velocity...
- nervoustrig replied to the thread Tuning Pinty tune Question.You are on the right track, but you can approach it as more of a cookbook recipe by lowering the regulator a bit and then dial the...
- A lot of times you can set your hammer spring to balance out the spread from your first shot all the way down to your last shot. We’ve...
- nervoustrig replied to the thread Tuning Pinty tune Question.It means the hammer spring tension is set a bit too light. As the pressure declines, the hammer is able to more easily knock the valve...
- nervoustrig replied to the thread Daystate Valve seating/leak repair assistance.Use a black Sharpie to color the contact faces of both the poppet and the valve. Apply a light abrasive* and spin them together for...
- nervoustrig reacted to Doc_pafumo's post in the thread RAW Rapid Size Belleville washer RAW HM1000x with Haha. Thanks so much! You totally saved my day. I’ve been searching for this for months and never thought of this solution
- nervoustrig replied to the thread Chronograph News.You could buy a chronograph for less than the gas plus wear & tear...but it’s a good reason to visit a friend.(y)
- nervoustrig replied to the thread Setting the regulator & hammer spring tension correctly.The general way of doing it is to adjust the hammer spring tension for somewhere in the ballpark of 97% of the maximum velocity...
- nervoustrig replied to the thread Air Venturi Noise During Pump.Quick update just to say I rechecked to see if the squeak disappeared after having reconfigured the check valve, and indeed it is gone.
- nervoustrig replied to the thread Snowpeak Snowpeak M60B regulator.Is the symptom that the plenum pressure is climbing to the same pressure as the bottle? If so, the O-ring on the regulator's adjustment...
- nervoustrig reacted to greenbeans's post in the thread FX fx impact m4 first 10 shots are slow with Like. Been there, done that :) polishing the valve rod to a mirror finish will definitely help. But it will not 100% prevent new gunk building...
- nervoustrig replied to the thread Air Venturi Noise During Pump.My standard Avenger makes a conspicuous squeak on each pump stroke when filling from a hand pump, so I suspect what you are hearing is...
