Nealgl1985's latest activity
Nealgl1985 replied to the thread American Air Arms Any skilled machinist out there?.Is this the pic you are looking for? @Airgun-Revisions- Nealgl1985 reacted to Airgun-Revisions's post in the thread American Air Arms Any skilled machinist out there? with
Like. Show a pic of the side of the brass valve that made the damage. Just below the TP. I’ve seen this happen before and it’s usually due to... - Put some new clothes on the 2021 Huben.
- Nealgl1985 replied to the thread American Air Arms Any skilled machinist out there?.@sb327 It is just deep scratches from the valve. I wouldnt consider fixing it if I thought it was cracked. I inspected the orings and...
- Nealgl1985 replied to the thread FX My set up.How far are the groups from im assuming is what he is asking.
- What I carry it around in
- Nealgl1985 replied to the thread American Air Arms Any skilled machinist out there?.@sb327 you are correct. I was told the damage was done from dry firing the slayer. The valve scratched the surface of the lower and im...
- Nealgl1985 replied to the thread American Air Arms Any skilled machinist out there?.@Texas Iggie a lower is only $325 from the factory. I wish I could get 1. I messaged him again through the website this time. See if i...
- Nealgl1985 replied to the thread American Air Arms Any skilled machinist out there?.@Texas Iggie when I talked to Tom he said he was going to be making some lowers. He said he had valves in stock but i said id wait on...
- Im looking for someone to take on a project. I bought a AAA slayer 357 on the classifieds awhile back and it quit holding air. I opened...
- Nealgl1985 reacted to bernieorosz's post in the thread Taipan Taipan Slash first tuning report. with Like. I was unable to resolve my Slash magazine cycling problem even after many hours with the help of Taipan. Tony at Talon Tunes...
- I tried out my new NOE 357-136HP mold today. Since everything was in use, I cast some Lyman .50 Plains Bullets too. I’m hoping these...
- Nealgl1985 replied to the thread Has the AAA slayer been ended?.I dont see the slayers on their website anymore. I was trying to get a lower reciever for my 357 but it never happened. I messaged him...
- I've had 2 inch groups at 100yds with those slugs when moving at 820fps, but 880-950 would be your best bet.
- Nealgl1985 reacted to gendoc's post in the thread got this fatty on the cardinal feeder @82 yrds with Like. it looked as big as a coon, had to look thru an optic. sent a CPDUM from my ataman M2R compact bullpup......its a lights out machine ...
