NateChrony's latest activity

yeah the uncertainty - covered that in this video a little: I've looked internally at a few of these & Its most likely due to the lack...

Radars... There was an interesting thread on AGF UK about radars, an old guy that worked on radars for 60 years popped in - he basically...

I'm somewhat confident in saying I've most likely shot through more chronographs than any person - because I live shoot calibrate every...

The distance from center to top is ~15mm & bottom is roughly the same, however alignment is absolutely critical (new software has...

The only other Chronograph i've seen with repeatability accuracy is the Pro-chrono DLX, but they specify it in timing ns... kinda...

Your expectation of chronograph accuracy is far too high - as is most peoples. Due to manufacturing tolerances, unless they're live shot...

My Garmin Xero doesn’t work well in my basement range which is only about 20 ft & a lot of stuff for the radar to bounce off of so I...

That is a plausible reason, unfortunately it would be hard to confirm without knowing the manufacturing tolerances. But there may be...

Going through a rebuild & struggling too... keep blowing out the green orings. Did get a few to work ok & then it was like the check...

I can only talk about the regular NateChrony - some barrels it does affect POI, others not - depends on the barrel. So i'll never make...

(NateChrony - NOT the BuckChrony - ref BuckRails product page for the buck chrony) Like a 457 Texan at a few hundred fpe? yeah no...