Mycapt65's latest activity

You probably already have but just in case: Check your stock screws are still tight Check the scope base and rings. Crack it open...

Thanks I'm not shooting rested. I don't have any luck shooting springers rested. I hold them. I lean my left wrist on the sandbaged ammo...

You're right. About pellet/bullet preferences. I just don't usually see such drastic differences. It was ok with the AA 8.4s. It had...

Thanks guys. Thanks I'll take a closer look inside the stock next time I have it apart.

OK this is an insult prolly six levels below your HW expertise! But something I always do with new-to-me guns, is give the stock...

Thanks Steve, that's a very appropriate response. I certainly didn't give it enough shots in this example to properly season or lead...

I'm still struggling to understand what's going on with the accuracy of this early Beeman 77. The wind was very light to non existent...

Well have to agree to disagree. Springs can be made reasonably consistent. Your experience with aftermarket springs is typical of...

They couldn't mass produce a guide fit as good as a custom fit, but they could easily mass produce one that fits well enough to reduce...

I’ve purchased 4 HW’s in the past 2 years (2 98’s, a 95, and 35E) and every one had annoying spring buzz. Don’t have the patience to...

I think you might mean Trenier. https://www.trenierairguns.com/ I've bought well over a 100 tins of JSB and H&Ns in three calibers...

So true on all accounts. Having been a Mercedes parts guy for two years and BMW tech for eleven years, I can tell you from lots of...

Your spring probably got bended a bit from use , when there's some bend in it there is less twang . But i don't understand why they...

I've worked on one or two.

There is plenty of .20 cal. pellets available now (now is the operative word here), however that wasn't the case six months ago or for...