Recent content by msg1979

I havent noticed any accuracy difference when changing the pellet probe to a pin probe in my Daystate Delta Wolf Perf. .177. Same with my BRK Ghost. On both rifles the pin load the pellets and slugs smooth.

I have stopped using .177 jsb exact 8.44 and heavy 10.34. I get better results with qys 8.48/9.56, h&n baracuda 8 8.44, h&n ft 9.57 and h&n match 10.67. I get too many fliers with jsb.

Thx!

Can you link to the correct size o-ring in poly 90d?

Thx. Looks like the stock redwolf need a tune. Ill go for tuning when heliboard arrives

Thx! The regular monster at low setting - which gives 830fps - do not group at all. Only the redesign do group at 815fps in low setting. I will try to see if the regular monster will group at another speed - but need heliboard to arrive for that I would think that 810fps to 830fps - 20fps...

I have ordered a heliboard. Should arrive in 10days

Thx Which 13.4? The monster or monster redesign? Mine doesnt shoot the 10.3 at low setting - 920fps. Group is too big Mine doesnt shoot monster 13.4 at 830fps in low. Groups too big It shoots 16.2 930fps in high and 13.4 monster redesign 810fps in low - perfect groups. Is this ok from a new...

Yes. I have seen that. Very good in depth review. But it doesnt tell how the riflexshoots 13.34g and 13.43g. Only slugs and beast

Zan 13 did not work on any of the settings. I have ordered a heliboard - but im curious about the stock power settings - what they do the best with.

I have bougt a new Redwolf .177 HP Today I did shoot it for the first time. I did 3x pull trough to clean barrel before shooting I was at the understanding that the setting low, medium and high should be used with JSB heavy, monster and beast (or equal from Rangemaster) due to writings and...

On my .177 fac 700mm I shoot 16.2g jsb beast at 120bar. Ive made a factory set that allow adjustment from 700-1050fps With your shorter barrel it should be possible at 150bar. Problem is that the factory set that comes with your rifle doesnt allow it. You have to make a new factory set

For a 100-130bar regulator setting its the preferably to have a ~36ccm plenum for better air effeciency - with same power?

For FT - be aware that the alpha and delta can have a first shot with a small drop in fps on a fixed volt/pulse setting. This occures when the rifle has been off and are turned on again. On my delta - if I shoot a 13.43g at 160b - 66v 2100pulse - the first shot is 20-30fps (890fps) lower than...

Can you link to a working video?