Recent content by MrAwesome987

I received my oring kit on Friday. Planning to attempt the rebuild sometime this week. Anything I should know? How long would you estimate the rebuild to take?

I did not realize it was best to store the gun with the tank full. It does make sense though. My thinking was if I stored it with the tank disconnected, I would be able to reattach and shoot quick(ish) next time I had the time. What is the recommended kit for rebuilding it? Are there any other...

I have had an Impact M3 for about 2 years or so. I haven't had a chance to shoot it much recently. It had been leaking around the larger o-ring behind the first regulator, so I had stored it with the bottle off. I am not sure how much air was in the bottle when I stored it, but when I got it out...

Where did you order from? With those settings, an 18.1 grain pellet is going to be going wayyy too fast. I have mine shooting JSB 18.1 grain pellets at ~925 fps with the following settings: Valve Adjuster: All most all the way out. Probably around 4.5 lines (if there were a .5 line) 1st...

Thanks! I got the FX Chronograph in yesterday, but I won't have time to mess with it until Saturday. Hoping to get it dialed in correctly!

Thanks for the response! I did read the manual and found the suggested setting for the rear regulator, but could not find anything for the other settings. I adjusted it today to 150ish on the front and 80 for the rear. I shot 3 magazines through it and it seemed to hit pretty accurately, but I...

Hello, this is my first post here. Hopefully I'm in the right place. I recently received my first PCP air rifle, an Impact M3 Sniper in .22. I ordered it online, and the retailer did open it and check it, and provided a card showing that it was shooting around 900 fps using JSB 18 grain...