Recent content by mohidris017

You can also get springs from AliExpress 10mm OD 1.4 Wire diameter they work good my agt regs works very good and always stop at the set point i have gone all the way to 250 bar on the reg and it was working great the washers comes stacked 2 facing each other (( )) (( )) (( )) (( )) for higher...

I have shot the 30gr with my vulcan 500 laser accurate 170 bar will get the 30gr going around 930 fps you will need a heavier spring you can use talontune spring I have done a lot of tests on the Vulcan factory regulator and the Huma The factory regulator is amazing and very consistent build...

30gr at 930fps 130-140 bar for consistent STD

This listing has been renewed

This listing has been renewed

This listing has been renewed

This listing has been renewed

This listing has been renewed

This listing has been renewed

Selling my Vulcan 3 700mm .22 Cal ****** 1250 shipped ****** Comes with 2 mag, agt soft case and fill probe Upgraded 700cc bottle The rifle tuned to shoot H&N 30gr .218 at 1024 fps laser accurate regulator set precisely with a tester at 170 bar No bipod no scope Donnyfl fatboy with extension...

I have Arken Zulus 5x20 with range finder and ballistic calculator excellent condition Include eight batteries and external charger 500 shipped **I can do a trade with element immersive scope**

I don't have any RTI rifle I can't advise you which one but in general all PCP regulators are very similar your regulator is not working so you have to take it apart it will be easier if you just take it out inspect all the o-rings and the sealing surface on the piston

Check all the o-rings on the regulator one of them failed

This listing has been renewed

I have 6 tins of JSB KNOCKOUT .218 Weight 25.39 one tin missing half I can trade with h&n hp2 .218 or sell them for $60