Recent content by MikeyMike73

There is enough metal for a .30 mag. Just need some modification to the bearing. In a short while it should be finished.

How can I edit or close a WTS posting? I can't edit it but also can't close it. And there is no help post on top of the forum...

They did not drop the valve. It works great. Just made some changes to the valve seat and valve nut, so it doesn't come loose.

@kaylaindy ?

Hey In your most viewed YouTube posts are three AEA guns. Did newer guns look better than you thought at the time of this post?

878,20

​​​​​​ I am selling some of my Evanix pcp rifles. Five pieces with full auto electro-mechanical technology (such as an Airsoft gun) and a onw semi-auto based on air. The rifles have been fully checked and improved in terms of electro-mechanical technology (metal parts in stead of platic etc.)...

Thanks for all the answers. My polishing etc. did nothing for accuracy. Only around 680-700fps they seem to work a bit better. I will try the FX barrel maybe later this weekend. It could be that the smooth twist is better for these light pellets. I also tried these pellets today in an Evanix...

With FX liner still whistles. I did not test at the range but took everything apart. Polished all edges and parts that could damage the skirt. Will try this afternoon...

Maybe the red marked location is causing the skirts to be damaged. Anybody experience with that and/or modifying this part? I did not check it on my gun yet, since the JSB's are performing fine. But that could be due the a better fitting in the magazine and the higher weight.

I bought some boxes of HN FTT 20,06gr for my LCS since JSB's are out of stock. I found out they are all over the place. Even at 40 yards the are not grouping at all. Left, right, low,high. I have some JSB's (Mk1 heavy 33,95gr) left and they still perform well so it isn't the gun itself. The...

I am selling some of my Evanix pcp rifles. Five pieces with full auto electro-mechanical technology (such as an Airsoft gun) and a two semi-auto based on air. The rifles have been fully checked and improved in terms of electro-mechanical technology (metal parts in stead of platic etc.) and are...

Never shot with a prophet. I own some Evanix rifles and currently use my LCS SK-19 a lot. I am thinking about a FX Impact M3 bronze but next to all the YouTube videos of how accurate they are I also read about issues with o rings and other things. What would be the best alternative to the...

If the compressor builds up pressure when connected to the gun then the quick connector of the compressor may be broken or the valve of the gun is broken. Either way you have some work to do...

Is the cilinder still ok. So just the piston will fix the compressor? I have one too. No problems so far. But a spare piston is good to have in stock? Any more parts that are needed?