Recent content by Mike Kunte

3x1mm 5x1.78mm

I have no problem replacing the o-rings regularly. I bought 5 of each size yesterday for around a Dollar. That's cheap enough for such a fantastic device. Now if I could just stop the leak I'd be fine.... ;)

Yes, you are absolutely correct! That's the big pity - once you've used this item, it's VERY difficult to go back to the caveman way.... ;) I certainly hope I'm able to resolve the issue. I just don't want to spend more (I see the seal kits are aound 267 Euro) to FIX a brand new item.... :( I...

Hi, ctshooter, Thanks for your reply. I also suspect part #3. It's a pity that it's happened with a new unit. Mike

Thanks, GA_LeadHead! The first one I had maintained pressure for about 3 days before it developed a leak! I would never leave the valve open after the shooting session, but it's very helpful during the session. You know, if it was a $20 item, I'd let it ride... but man! Is set me back Rand 3000...

Thanks! Ok, it leaks from the front of the gun, at the discharge side. Using tape there is moot - it would only be useful whilst filling to prevent blow-by under pressure. Even the female Foster fitting removed, it bubbles out there, i.e. the leak is upstream of the fitting, inside the main...

Hello Delooper! My unit simply free-flows as soon as I open the valve on the cylinder. It's almost as if the adjustment screw is slightly too far in. But it's properly adjusted. I checked this by adjusting the screw in and out. No change. When filling the bottle, I never have the valve...

Thanks! I'll send him a message, but I'm based in South Africa.... Mike

Here is the schematic.... Also, here are the O-ring sizes....

Hello all! I purchased an Edgun Easzyfill unit some 3 months ago. This is an expensive unit, but as many of you have already attested, an absolute pleasure to use. However, when it began leaking air (from the front discharge), I returned it to the dealer, who replaced it. The dealer then...

I had the same worries about using higher pressures, shorter valve opening. I received this advice from a friend: "Rather use higher pressure with less hammer, uses less air, a quick high pressure burst versus a longer lower pressure burst is more economic on air." I have found this to be true...

Great question, Jagbender! I've recently been asking myself the same question. I was experimenting with a new tune on my FX Maverick in .22 cal, with 170/130 settings on 1st and 2nd reg. Filling to 250Bar on the bottle, I could achieve about 2 - 3 mags (18 rounds of .22) before reaching the...

Also check that the hammer spring adjustment screw is not out too far. Having it project too long can cause the Mav to not cock properly. If I recall, it should not be turned out more than 6 or 7 full turns... Hope this helps Mike

BrocStar! This is an interesting question, and one I've been asking myself lately. I'm running my FX Maverick @ 170/130. With that in mind, surely one could run all the way down to 130 (or slightly above) before refilling? The manuals say that the pressure dirrerential between the two regs...