Recent content by Michael

Acetone is really strong. If I ever remove this I’ll try rubbing alcohol first!

I used a 1” latex paint brush and tapped it against the handle of a mallet that I held horizontally above the target.

This DIY garage art was inspired by the Utah Airguns custom shop. They built an M4 with a similar “splatter paint” job. I don’t have the means to cerakote any longer, so I wrangled up some less-than-permanent acrylic paint.

Legitimate Q&A regarding how the tariffs affect our sport and/or product availability are always welcome.

This thread isn’t a political free for all. Please ensure your comments remain in line with our rules.

This listing has been renewed

This listing has been renewed

I hope you’re good at replacing o-rings too! But seriously, have you ever shot that many shots in a single day. Sounds a bit unreasonable to me.

I have it zero‘d at 15y. It depends how big my target is, but most of what I’ve done so far is within 30y. Red dots (single reticle red-dots) don’t lend themselves to accurate hold-overs.

This air pistol is insanely fun, accurate, powerful, and efficient! 🫶🏻 I thought about putting this in the Air Pistols section, but TBH Air Pistols never really excited me until this one! Are people missing out on the likes of remarkable products because they’re “stuck in the past” using the...

Yeah buddy! I typically only use stuff I REALLY like. 😉 Have fun

Yesssss!

I’m not a fan of the burst of air inherent to that design either, but it is what it is. Yes the parts go back in the fill port side of the V-block. If memory serves insert the end with the o-ring first then the spring (as shown in the middle picture). Insert it back onto the V-block using...

I don’t have any experience with the RAW moderator. Though it sounds like it should be easy enough to remove with a bit of heat. FWIW I actually broke the bond between the carbon fiber sleeve and the barrel by accidentally tightening a moderator too much. If you can remove the mod & the sleeve...

Given the small volume, I'd like to see a higher pressure air tube as standard.