Recent content by mcp

Hi, please send us a message with your order # and we'll take care of you. We discovered that we got a batch of stem that's 0.04mm too big on one end. Unfortunately a few valves with the bad stem got out...

Please PM me your order# and I can check the status for you. It's taking a bit longer than usual for shipping due to the postal strike and the holidays but shouldn't take more than 2 weeks to get to you. Now back to your original question, the orings are FKM but Nitrile orings will also work...

We want to emphasize that we stand behind every product we sell, going as far as replacing magazines that went in cloth dryer. We certainly don't expect the magazine to deform after being left out in the sun or on the dashboard. Our decision to switch from PLA to PETG material was to respond to...

Hi OP, Thank you for bringing this concern to our attention. I would like to clarify a few points: The magazine you received was from our very first batch, produced in August 2023. These were printed using PLA, which can withstand temperatures up to 57°C (134°F) before deforming. In September...