Recent content by Maxgasmekl

Ok, I will give that a try. So set it on low and turn the hammerspring in, so it rises from 750 to 870ish?

Thank you for clarifying. If i move the transfer port to low as it is now - it will be in the 750 fps range. And that is a bit to low. Would you recommend trying the hammerspring adjust first and then maybe the reg adjust? It wouldnt help just to lower the reg pressure to 1600 psi to get the gun...

Ok, thank you😀 But isnt it hard to tune that way when the fps goes up and down as the listed numbers are showing? How is it loosing air?

Ok, so either I should increase the reg to 2000psi or increase hammer tension even more, although its alteady shooting way above the 900 fps range ( most of the time)

I havent done any tuning yet:/

As per my earlier posts my Avenge X has been somewhat inconsistent in its shooting behaviour. I ended up cleaning the barrel with a soft piece of cloth pullet througt the barrel from the breech side and out and also tightened every set screw down. I bought some JST Exact Heavy Diabolo 10.34 gr...

But when I go back to the JSBs - that shoot closest to the aim point - its accurate again.

And yes - I know. I should recieve my chrono one of the next days🤩🙌🏽

Its an Avenge X Classic synthetic I have. Dont know if the trigger is any different. Also I tried to shoot some groups today. The JSBs 10.34 Diabolo shoots great overall, but the Crosmans 10.5 seem to do well now that I have tightened everything down in the barrel. But both the Crosmans and the...

That looks good🤠🤠

So - a quick update: I ordered some JSB Exact Diabolo 10.34. Took the gun apart. Cleaned the barrel, took of the shroud, discovered that the endcap that the shroud screws into on the actionside has a set screw that was loose. Also the other end of the barrel had a slight gap between it and the...

I got it of with a little heat and some rubberbands. I dont know if the muzzle end is ok?

Thank you😊 but No - its the “action” end. Closest to the trigger that seems stuck

I have taken the shroud of several times. Cleaned the barrel like a million times. Regreased oring with silikone oil. And even when the shroud is off of the gun it is impossible to release from the end piece. I live in Denmark🤠I guess I must try the heat-method tomorrow. Ps: where is that...

By the way its a .177. I dont think I have ever mentioned that in this thread. And I dont know about speeds yet. I am waiting for my chrono to arrive. I know this is kind of an important item to own, its just weird that sometimes it shoot fine 1/2 inch groups at 22m for at group of five or more...