Recent content by masterblaster79

I've had problems getting my 22cal to group so i posted on a airacuda Facebook page looking for answers. I posted pics of my barrel and a rough patch inside it that i have concerns with. Travis whitney commented "just lap it out". To me that is the wrong response. He should have said, sent it...

Can you show a picture of where this hole should be? My stock fits very snug.

Is this the method you guys use?

What do you polish with?

Did you polish the inside of your barrel?

Thats very good. I bet it's still under 1 inch at 75yds.

Motorhead would you help point me in the direction of your documented work so i can learn what might help my accuracy?

You said tack driver so what is it grouping like and at what distance? I also have a max 22 cal. I'm hoping to improve my groups also.

So did anyone decide if over polishing a barrel is possible or had a bad experience after polishing a Barrel?

Sounds like a good problem to have.

What size groups are you getting and how many yards are you shooting ?

Ok i wanted to give an update on my progress with my airacuda max 22 cal. After adjusting the hammer spring adjustment screw i landed on 2 and 3/8s turns out from all the way down. With the NSA 20.2gr slugs in .217 diameter 9 out of 10 shots measured .620 at 50 yards. I then moved my target out...

Ok thank you again for your help.

I shot 10rds of the NSA 20.2gr at 50yds and shot a 2 1/4" group. I was wondering should i adjust my hammer spring because there is a pretty loud spring sound when it fires?

I have digital calipers that do measure to .0005 but are you saying they won't measure that accurately?