Recent content by Martinman

No luck. Used Dawn and water mix and checked all locations on the air tube. Zero bubbles. Topped the gun off and checked again and still no bubbles.

Okay, I removed the air tube last night. Everything looked good. O ring didn’t show any damage or deformities. Regreased, replaced air tube and charged back to 230 bar. Today it’s leaked down to 180 bar. So now I have to find the leak. Any suggestions on best methods?

I’m assuming your wanting the outside diameter. Is that correct?

I haven’t taken anything apart yet. Waiting in my grease to get here.

Gotcha. That’s why I wanted to get opinions on it.

Good deal. Thanks guys!! I will remove and reseat when my grease gets here. Oh I almost forgot. What about using the hole where the valve sits? (On the dreamline you can see the valve through a hole that runs from one side of the block to the other.)Using a small Allen to slowly open the...

Hello, You airgun masters of the universe. I recently purchased my son an FX Dreamline Tac (sweet gun) and I’ve noticed it has a slow leak. I’m wanting to remove the air tube to check the O ring and reseat it. But I don’t know the proper degassing method for that gun. I don’t want to bleed it...

Found it!!! After shooting numerous times with no problems, I took the gun out of the case a couple of days ago and seen the front elevation lock down screw for the FX no limits mount fall out. Makes total sense. It must’ve loosened up and allowed the front mount to drop. Which explains why it...

Thanks for all of the feedback guys. To address some of your questions, It is a SFP scope and all shots when zeroed and shots taken when I noticed the POI change and shots taken after it corrected was at 10x. One of the first things I done was check the mounts and the scope. Everything was...

I only removed the ST liner from the STX system when I cleaned it. But that was before all of the zeroing was done. im not going to put anything on it to lock it yet. Because if this happens again I want to see whats moving if anything. And thanks for the help guys!!!

Ok, just shot 3 mags through it. And the dang thing was back to zero. Not close, but dead on. The only thing I done was move the hammer spring adjuster not hardly a quarter turn to the right to see how loose it was and then marked it. The mark didn’t move through the 3 mags. Here’s what I’m...

I just checked the nut and it’s no super loose or jiggling. I can turn the nut with a little pressure so it’s not locked in place either. I made a mark and I’m goin to put a couple of mags through it to see if it moves. what is the expected FPS change per 1/4 turn?

Unfortunately I do not have a chrony. Do you think I can tell just by looking? That sucks, cause if it is loose and I don’t have a chrony, then who knows how far it has walked out. And I don’t have a way of effectively setting it back to know what fps I’m shooting at. 

I haven’t checked anything yet. I wanted to get some feed back from you guys first

Purchased a new WK compact and have had 2 poi shifts within a week. First time I noticed yesterday morning when shooting at starlings in my orchard. They were only 37 yards away. By my range card that I made after the first zeroing (My 2nd zero is at 50yds) it should’ve been 1 mil hold under...